护坡钢模具是现在建材工程中广泛使用的一种钢模具制品,对于原材料的选择和制作是有一定的生产要求和注意事项的,因为这关系到整件模具的质量和性能是否达标。
Slope protection steel mold is a kind of steel mold products widely used in building materials engineering. There are certain production requirements and precautions for the selection and production of raw materials, because it is related to whether the quality and performance of the whole die can meet the standard.

新的护坡钢模具我们要检查模具上的模柄螺钉、打料螺钉是否松动的现象,如果有的话需要上紧.还有就是模具的导柱、导套是否干净清洁,有无润滑油,如果不干净的话,需要我们对模具进行清理之后,加入清洁的润滑油.润滑油一般都要选择粘度较高的,像我们常用的50#机械油.
For the new slope protection steel mold, we need to check whether the die handle screw and the punching screw are loose. If there are any, they need to be tightened. In addition, whether the guide pillar and guide sleeve of the mold are clean and clean, and whether there is lubricating oil. If not, we need to clean the mold and add clean lubricating oil. Generally, the lubricating oil with high viscosity should be selected, Like our commonly used 50% machine oil

注意模具的模柄上平面是否能和滑块的底平面紧密接触,如果连接不紧密的话,极有可能会出现裂缝,如果有裂纹,要及时更换模柄,避免模具报废或损坏冲床的现象.
Pay attention to whether the upper surface of the handle of the slope protection mould can be in close contact with the bottom plane of the slide block. If the connection is not tight, cracks may occur. If there are cracks, the handle should be replaced in time to avoid scrapping the die or damaging the punch

同时要注意模具在使用过程中,要每2小时给导柱加一次油.我们还有注意模具上是否毛刺和杂物,这些毛刺可能会导致我们生产的过程中出现误差,如果发现有毛刺的话有及时的处理掉
At the same time, we should pay attention to the mold in the use process, to add oil to the guide pillar every 2 hours. We also pay attention to whether there are burrs and impurities on the slope protection mold. These burrs may lead to errors in our production process. If there is any burr, it should be handled in time